Roof Water Diverter Installation

Cost effective solution that is easy for professionals to install.

Roof water diverter installation.

A rain or water diverter will keep a doorway. Our diverter comes fully assembled and ready to install by qualified contractor. Loosen up the shingles by. I need to prevent this problem as i do not want a wet basement.

To install a rain diverter on your roof. I have water running off the side of my roof as evidenced by the mud splashed up on the side of my house and a water channel in my flower bed below. Can i install the rain diverter on the side of a roof and if i do how do i get the water back into the gutter. Exposure at the other end to create a drainage pitch.

Slide the diverter in. Using a pry bar or putty knife loosen the second row of shingles up from the edge of the roof where the diverter will be located. Start by cutting the flashing with tin snips about 2 3 feet longer than the doorway you want to protect. Lift the shingles to nail the.

Roof rain diverter installation steps sand underside of flashing with 80 grit sandpaper to help paint adhere. The edges of product s body are bended inside to prevent water back up under roof shingles. Order your diverter online and receive within a week. Slide one end of the diverter tight to the bottom of the shingle tabs and leave a 1 in.

Slant the diverter so that one side is slightly lower than the other to allow for drainage. A drop of 1 is plenty for a 6 diverter. Slide the long side of the diverter under the shingles leaving the lip of the diverter hanging out. Diverter is made from 24 gauge aluminum that is rust resistant and flexible to accommodate different roof angles.

Spray paint bottom surface and up turned edge of flashing to match color of roof. Installing a rain diverter on your roof is useful if you have a place where water runs and you don t want it to. Climb a sturdy ladder and locate the second row of shingles closest to the roof edge. How to install a rain diverter on a roof 1.

Thick bead of clear silicone caulk on the underside of the drip edge lift the shingle tabs up slightly and slide the diverter under the tabs. Roof valley rain water diverter is the only product on the market that solves the problem of overflowing water on an a roof. Cut flashing in half using aviation snips. Next carefully break the seal on a row of shingles above the doorway with a flat pry bar or putty knife.

It prevents rain water from cascading on the inside corners of the shingle roof. Eliminates the hazard of owerflowing water and ice and prevents dangerous slip and fall accidents.